Making Cavallettis

Equine Mine Archive on May 14, 2009, 8:09


I am working on making Cavallettis. It started with a trip to Home Depot and checking out all the "plastic." I found these 4x3 drain basins, drilled two 1 inch holes on each side.Next, I cut 3/4 inch PVC pipe into 16 inch long pieces and stuck them thru the drilled holes. I lined them up and then used electrical tape to keep the pipe in place. Just kept going around and around until the pipe was secure.I capped the ends of the pvc pipe with little caps they had at Home Depot for 13 cents a piece. It gave it a finished look. Then I cut a 10 foot by 4 inch PVC pipe in half and stuck them into the

read more ยป